Gas Pre Heater CO2 & Nitrous Oxide

Gas Pre Heater CO2 & Nitrous Oxide

Gas Heaters from Misatu manufacturig keep your welding gases flowing and prevent down-time and damage to your equipement.

As gas is drawn from the supply cylinder, it can reliquify and/or freeze your equipment due to temperature change caused by evaporation, stopping your work cold !

Since they are not insulated for outdoor use, the heaters must be protected from moisture and weather or climatic conditions that could cause electrical equipment to become a hazard.

Misatu gas heater with a heating element, a thermostatic control, and indicater in a totally enclosed unit that heats the gas to a uniform useable temperature before it enters the regulator/flowmeter.

Advantage :

  • All NUT / NIPPLE ARE DETACHABLE
  • HEATER CARDTRIDGE EASY REPLACABLE

WARNING :

  • FOR USE WITH NON-COMPUSTIBLE WELDING GASES ONLY.
  • MISATU GAS HEATERS ARE INTENDED FOR USE ON 36V / 42V / 110V / 230V / 50/60 HZ, SINGLE PHASE AC ONLY. USE ONLY WITH 3-WIRE GROUNDED, ELECTRICAL EXTENSION CORD AND SOCKET.